Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / k.prakashchandra
This question is a little vague.Hence,there are different
answers.No attempt is done to determine the correct
answer.I am furnishing a few extracts from Rule :2(av) of
IE Rules 1956 regarding the voltages for the benefit of
readers.Voltage means the difference of electrical
potential measured in volts between any two conductors or
between any part of either conductor and the earth as
measured by a suitable voltmeter and is said to
be 'low 'where the voltage does not exceed 250
V ,'medium 'where voltage does not exceed 650 V,'high'
where voltage does not exceed 33000 V, extra high where the
voltage exceeds 33000 V -All under normal conditions
subject to variations allowed by rules , which are 6%,6%,
+6 %& -9%, +10% & -12.5 % respectively.
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
How to minimize the eddy current losses?
10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)
What is called limb of a transformer?
WHAT IS THE MEANING OF BALANCED / UNBALANCED IN STABILIZER TYPES.
What is George phenomena to start the synchronus machine?
checking procedure of capacitor based motors.used in fans etc?
importance of reactive power management
why all the feeders are designed in a particular manner ... is there any reason for that???
critically criticize the application of ring main unit in power system
Can you tell me more about pu systems (per unit systems )calculation in large power systems? how to get the base for voltage and power in generator, transformator and transmission lines?
what is Insulation monitoring device. where it is used? (in switchgear room or control panel or in field equipment)
How to calculate Number of Earthing Pits....???
why motor range is available 22kv,30kv,37kv,45kv and so on? why motor range is not available 21kv,24,25,26,27kv and so on?
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
What is 11 N1 and 12 N2 in single phase Transformer ?
