Answer / yashwant

SEE THE SIMPLEST WAY WILL BE DEPEND ON YOUR REQUIREMENT OF
PROCESS, WHETHER YOU WANT SLOW OR FAST RESPONSE AND ACCURACY
YOU WISH. P VALUE FASTEN AND SLOW DOWN PROCESS, IF YOU REDUCE
VALUE OF P LESS THAN 1 PROCESS WILL BE ACTING VERY SLOW AND
ACCURACY ALSO WILL BE GOOD, AND IF IT IS MORE THAN 1 SYSTEM
ACTS SOME WHAT FAST AND FORWARD O/P IS EXPECTED.
I VALUE DECIDE THE SPAN AND SPEED WHILE REACHING SP AND AWAY
FROM SP. D IS USED FOR VERY FAST RESPONSE IE ON OR OFF VERY
FAST ACTION IT IS USED VERY RARELY AS PER PROCESS REQUIREMENT

why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.

0 Answers  

---

Differentiate between ultrasonic flowmeter and radar type flow meter

0 Answers  

---

which type signal in & out in dcs

4 Answers  

---

can someone tell me about electronic speed switch &how it conect with proximittyswitch?(with dgm)

0 Answers  

---

how to calculate flow range in DP tx

1 Answers   Karnataka Power,

---

Intools training

1 Answers  

---

how to derive kg/cm2 to mmwc? complete derivation.

11 Answers   L&T,

---

What materials are used in thermo wells?

0 Answers  

---

how many parts of valve positioner?

1 Answers   Kentz,

---

what is maximum vaccume?

4 Answers  

---

why we set -10 volt in vibration sensor output,why not +10 volt

3 Answers   Sabic, TVS,

---

In RTU Panel we are having several Analogue & Digital Inputs /Outputs. We are recently facing some problems over Analog inputs , which are not updating properly (But Digital Input are updating normally) Can any one tell me from where the problem is creating , we have checked PLC CPU card, Analog Input card & we reconfigured ,But still the issue is there. Issue : 1. Sometimes Analog values are updating & sometimes not. 2. Analog values are not updating normally , showing some wrong Values 3. Total dead (0 value) Analog values are Level & flow measurement from the field instruments. (But in field the instruments are working normally & Displaying the values normally in local display unit) This problem we are facing in our Water Plant. If any one experienced this same problem or having any ideas related to our issue PLS send your valuable Answers/Replies...

6 Answers   L&T,

---