Where is wet leg is used?
Answer / Km. Lata Rani
A 'wet leg' is a term used in the oil and gas industry to describe the submerged portion of a fixed offshore platform. It supports the weight of the structure, connects it to the seabed, and transfers hydrocarbons from the wellheads to the processing facilities.
| Is This Answer Correct ? | 0 Yes | 0 No |
What is super thermocoupal?
whatis virtual instrumention?
It is desired to reduce effect of 50Hz pick up in a thermocouple measurement. If a third order LP filter is used for this, what should be its cut off frequency, if gain should be 0.001 at 50Hz.
how will you segregate the alarm levels in alarm management system during factory Acceptance Test
why 4 to 20 ma used at 0 set
what is mean by hot loop and cold loop testing, whts different between both
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
in which mode of the zener diode act when load voltage is approximately constant
How to Calibrate Temperature Switch in field
Name different parts of a pressure gauge.
who discoverd ohms law?
tell me about the instrumentation,what is the actual need of it ?what are the characteristics of a IC engineer ?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)