Answer / praadeep_dd@yahoo.com

A sphere gap is a type of voltmeter. It contains 2 spheres
one of it is connected to Earth n second is connected to the
point of which voltage is to be measured. The gap between 2
spheres is reduced till a breakdown takes place. After a
break down the gap is measured n the gap is compared with a
standard table.
Eg. if B/D takes place at 2mm then the voltage recorded in
standard table for 2mm is known.

what is motor

6 Answers   HBL Power Systems,

---

Why in DC drive u r using in Klin operation in Cement Plant?

7 Answers  

---

if any one phase of the 11kv/415v distribution transformer not delivering the supply voltage what will happen

2 Answers  

---

what is the use of spherical metal balls attached on to the earth wire of transmission over head lines?

2 Answers  

---

Sir, why generating power plant operating at above 0.9 lag? detail explaination?

1 Answers   Kirloskar, L&T,

---

What is a unit of gravity (Battery)

9 Answers  

---

a distribution transformer(3 phase)supplying 440volt per phase.now suppose one of phase voltage(230volt) becomes zero.what will be the cause ?

3 Answers  

---

What is the difference between phase, neutral wire and earth cable. if neutral is connected to ground, y we need earthing cable? what difference in hot and cold wire? do neutral wire carry current?

1 Answers  

---

Generally In transformer Tap Changer on HT side, but I have seen in 66KV side in 220/66 KV, 100 MVA, Areva make transformer. Why ?

7 Answers  

---

Y phase plates are used in transmission line??? what is there need???

1 Answers  

---

Why the output of OP-AMP is always less than Vcc?

1 Answers  

---

What it the purpose of parallel phasing transfomers??

4 Answers   ABB, Reliance,

---