Why the output of OP-AMP is always less than Vcc?
No Answer is Posted For this Question
Be the First to Post Answer
how to syncronize two dg sets
What are the safety devices on Cumins Diesel Generators from 500 kva to 1500 kva.
1.where in India the maximum transmission voltage is operated? 2.what the methods are used to cool down the transformer?give the specific ratings of the transformer & specific cooling process. 3.how zero & negative sequence reactances are formed in a rotating machine when fault occur in the system?
how we can to the synchronization in transformer. What are the conditions for that.
where used of HVDS system.
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
why the three phase transformer's star point does not sparks or seperated? while we often see that two phases touches each other it sparks and ocationaly conductor breakes out.
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
what is the difference between unarmoured & Flexible cable? How to identified?
0 Answers Priyanka Electricals,
What is the power ratio between power in Star and Delta circuit?
What is the permissible limit of shaft voltage for 6.6 KV motors ? Why? Is there any standard is available?
why impudance relay used for medium transmission power system? why not others?