what is high pot test on 11kv switchgear and how to apply
high voltage on panel what is spheare gap and how to
determine its celeberation.
Answer Posted / praadeep_dd@yahoo.com
A sphere gap is a type of voltmeter. It contains 2 spheres
one of it is connected to Earth n second is connected to the
point of which voltage is to be measured. The gap between 2
spheres is reduced till a breakdown takes place. After a
break down the gap is measured n the gap is compared with a
standard table.
Eg. if B/D takes place at 2mm then the voltage recorded in
standard table for 2mm is known.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
How many lightning arrestors to be installed on 50MX60MX10M building and is there any formular for that?
Differentiate between voltage and current feedback in amplifiers?
A low wet bulb temperature indicates
What is the simplest formula to calculate the rotor diameter of a synchronous generator?
A 2083kva AVR was tested, phase to ground shows continuity, what is the implications
What is minimum phase system?
how to calculate the cable current ratingand and how much of distance the rating will be ok will the distance is incresed what the action we take
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
how does a submersible pump work..?
What are m circles?
we have 2.2kw,Y,3000rpm motor but 6leads found in TB what happen if we connect in delta?
can you please send me the technical questions and aptitude questions of honeywell and jindal steel electrical engg. question paper my e-mail ID is(kkesavanraj@gmail.com)
surge tank, hrc fuse, earthing transformer, firm power objective type
do any one help me to get "C" license,, i have doubts ,,, if mediators ter pls call me,, my no is 8056640042
How many methods use the load flow solution?