Answer / mangesh

In gerator syncronisation there are follwoing three steps.
we will call machine to be syncronised as incoming machine
(1) same voltage
(2) same frequency
(3) same phase angle

Scoboscope is used for syancro. also there are another
method named 2bright 1 dark and vice vrsa.

The power angle delta between induced emf and terminal
voltage determines the power transfer.

Answer / lava kumar.v

1. Run first set to voltage and frequency and switch to the main bus bar
2.connect at least 25% Load if regulation is poor.
3.set upto voltage and frequency.
4.synchronize phasing up to bus bar manually or automatically

Above mentioned points are satisfied the Dg will ready for operation
* Adjust engine power as necessary if it takes most of the power it will go out over load ,This will bring down the system.

If a contactor need to replace with faulty one. what I want to check?

2 Answers   Bhel,

---

Relay setting for earth fault of reciprocating and centrifugal compressor motor feeder.Setting will be different or same?

1 Answers   Reliance,

---

what is the difference between ac and dc?

1 Answers  

---

Hi guys! Plz help me to answer the following questions. 1. What are the types of transmission line energy losses? 2. Why are the VLF are used some types of services? 3. What frequencies are used for reliable beyond the horizon terrestrial communication without repeaters? 4. To permit selection of 1 out 16 equi-probable, what is the number of bitis required? 5. What is the most common modulation used for telegraphy? 6. What is the multiplexing is used to increase the capacity of the optic fiber? Thanks

0 Answers  

---

what kind of quetions will ask in BHEL in interview? Plz help me?

0 Answers   Bhel,

---

In n high voltage 11kv system What happened if 1 of CT cable (IDMT) loose.Will e/f or o/c trip.please explain detail

1 Answers  

---

WHY KVAR IMPORTANT WHEN ANY PLANT IS RUNNING ON IT'S OWN POWER PLANT?

1 Answers  

---

Mention what are the different colors on wires indicates?

0 Answers  

---

Why capacitor blocks DC current?

2 Answers  

---

sometimes, eventhough the HV side of the transformer is opened there is a voltage in LV side .How is it possible?

4 Answers  

---

How many double suspension hardware fittings are required on a double circuit transmission tower?

0 Answers  

---

what is %impedanece

3 Answers   KSEB, Steel Plant,

---