Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / lava kumar.v
1. Run first set to voltage and frequency and switch to the main bus bar
2.connect at least 25% Load if regulation is poor.
3.set upto voltage and frequency.
4.synchronize phasing up to bus bar manually or automatically
Above mentioned points are satisfied the Dg will ready for operation
* Adjust engine power as necessary if it takes most of the power it will go out over load ,This will bring down the system.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how to check three phase motor torque value?
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
In all analog voltmeters or ammeter showing some small size symbols. as well as a star and in star 2no. digit, resister symbol,and other. what is that's meaning ?
11 kv input, 66 kv input advantages
What is the formula for calculating the Instantaneous Short Circuit & overcurrent for any breaker
How can we calculate ac current from the given DC current when AC voltage is given?
Could Please Explain briefly. Why used stabilizing resistance series with High impedance bus differential protection relay.
dear sir/madam i want to get some knowledge about RRB EXAMINATION(section engineer) 1- what is minimum cut off 2- wht portion is major portion . 3- can any body provide Sample paper. thanks & regards ashish
Which type of questions well asked. ?
we need a ntpc previous papers
is it possible to test of bus bar in high rise building without completed full floor ?
How earthing/grounding done in aeroplanes and ships.
How select ELCB for 32amp. socket having quantity 12Nos. We have to do this wiring in PLANT. Please Also explain the incoming cable specification.
What is the application of Dyn1 and Dyn11 vector group of transformer?
how braking & making capacity of circuit breaker are calculated?
