Answer / pkpctc

E1 x E2
P =--------Sin 30 degree
X

Is there any answer.

Answer / sailaja

P=(Vs*Vr)(sin30+jcos30)
------
X

Answer / basheer ahmed

ACTIVE POWER= ((Vr)*(Vr)/X) watts

REACTIVE POWER= 0 (ZERO) VAR

What will be the sampling frequency that reveals the same sampled signal?

1 Answers   CCP,

---

how can we make cable shedule for controll wiring ? which details must be required for it.?

1 Answers   L&T,

---

WHAT WILL HAPPEN WHEN THE MOTOR FREQUENCY INCREASED OVER THE RATED MOTOR RPM THROUGH DRIVE?

3 Answers  

---

HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?

1 Answers   Adhunik,

---

what is the formula for calculating the phase clerance between two phases and phase to earth how to calculate the cable for a motor

1 Answers  

---

As we know multiplicity factor derivation equation is as below MF = main c t ratio / main p t ratio * meter c t ratio / meter p t ratio * meter dial constant Where in digital meters for HT kwh import export now a days meter constant are calibrated already which is 1 So my question is For HT 11kv 110 v line values are as below Main c t and p t ratio are 11000 v and 110 v and 20/5 means 20 amp and 5 amp Now meter values are 11000/√3/110√3 and primary and secondary amp are displayed as -/5 amp on kwh meter so what will be the MF for this meter ?

1 Answers   NEPC,

---

Please give the formula for converting from 1 tr refrigeration to kw.

2 Answers   Bugema University,

---

As per the theory current doesn’t flows in Neutral, but practically it is not applicable, explain why?

2 Answers  

---

What is the role of link in neutral in a three phase ac system?

10 Answers  

---

In 110V DC supply,if a closed circuit gets open, How can we identify the voltage which is measured after the resistor(4KOhm) which is open with negative.it shows 55V +ve when measured, also the actual positive source is 55V +ve .Because there is no voltage drop in open circuit. How can we identify whether this is the voltage which is series with the resistor or the DC source direct +ve.

1 Answers   GE,

---

In what circumstanced the CT used for protection relay will be saturated?and what will happen to the relay is the CT is saturated?

3 Answers  

---

What is Procedure the procedure to select CT's & PT's in 66kV and above substation?

2 Answers   BEL,

---