Interested to Buy Any Domain ? << Click Here >> for more details...
Find active & Reactive Power transmitted in a transmisston
line having Vs30 degree(sending end) to Vr(zero degree)at
receving end with line inductance X ohm.
Vs(30degree)-------------------Vr(zero degree)
X ohm
- 3 Answers
- 4827 Views
- I also Faced
- E-Mail Answers
Answer Posted / pkpctc
E1 x E2
P =--------Sin 30 degree
X
Is there any answer.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is Anemometer used to measure?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
What is the percentage loss for aluminium wire for HT line more than 11KVa
how can motor both beasrings insulation resistance can be check?
how the B-H loop obtain under the static condition
How to decide no. of Step and Kvar for APFC Panel 40 kvar MD: 33.12 KVA Avg pf : 0.8540
why we have to particulary use ACB for below ratings,even available of MCB,MCCB with that range ?
Anybody know how schematic diagram for reverse power relay? RPR for generator protection
can we make a electric generator,which can not use any type of fuel,air,solar,gas,thermal,coal,petrol,etc and able to produce electrical energy (or self electricity generating generator)
Can any one provide the inspection procedure of MIMIC for VFD panel? Details: If someone wants to have a mimic in the VFD panel what are inputs considered for the mimic(like on,off,trip) whether we are able to add speed variation in the mimic(if so how can we get) and what are the parameters to be checked in the MIMIC during inspection?
In hydel power plants, L.A's, S.C's are placed inside the control panel boards. what is the purpose? [already the total body was earthed to ground.]
What is frantic effect?
I have 4 DG set with 1500KVA rating. system breakers are 11KV & alternator are 415 Volts. Between alternator & breaker one stepup transformer used. i want to Know what is max. resistance for body earthing & 415 & 11KV V Neuteal earthing. my fault current is 14 times for 2 sec.
What is grid collapse? what is the reason for it?
What are the basic component of a cro?
