while conducting an experiment why we connect the armature rheostat in maximum

while conducting an experiment why we connect the armature
rheostat in maximum position and field rheostat in minimum
position

Question Posted / guest

1 Answers
4213 Views
I also Faced
E-Mail Answers

while conducting an experiment why we connect the armature rheostat in maximum position and field ..

Answer / k.prakashchandra

To limit the starting current in the armature and to keep
the initial speed minimum at start ,respectively.

Is This Answer Correct ?

5 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

what is the use of earthing ?

8 Answers Electrical Tech,

what is the clearances between phease to phease & phease to earth in 400 kv transmission line?

1 Answers Lanco,

Whet is IGBT.How it teste

2 Answers

In synchronous motor, how the field current is related to armature current..i know its inversely proportional..but concept wise...i was nt clear....pls help me...

0 Answers Siemens,

in gen traf what is ONAN , ONAF , OFAF and DYN

3 Answers

For example, if I use Star delta transformer for distribution, Can I Connect 230 V lighting load bewteen secondary phase & primary neutarl. What will be the effect, if I connect in this manner?

2 Answers

We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks

0 Answers

in transmission line, if the load is suddenly increased at the receiving end of the system the phase shift will (a)decrease (b)becomems zero (c)increase (d)not be affected

4 Answers Getco,

What is the difference between cylindrical-type and sandwich-type winding?

0 Answers

we want install 11KV generator to supply power 12km far from the power house.Load to be fed is 1MW.which conductor should we use and wat will be transmission line losses?

1 Answers CEM Engineering,

How to design the NGR Resistance

0 Answers

In a company the lines carrying 33KV but the load is below 10000Volts so we know that <11KV we can put 11KV lines but the lines are 33KV,..so how we can step down the voltage to 11KV with out erecting a substation

1 Answers

For more Electrical Engineering Interview Questions Click Here