What Is HO factor in power selection
No Answer is Posted For this Question
Be the First to Post Answer
What is the difference between IS:1554 (Part 1)/1988 & IS:694/1990 ? What do these two standards specify about?
Why and when NGR panel required. Is it necessary to design a NGR panel for a 6.6kV Alternator paralleling with Grid????
How would you supply a single house hold load from a 3-phase supply coming out of a sub-station?
What happen if field ckt is open when a sailent pole alternator connected to infinite bus
what is the generator rating for 40 amp load of 3phase motor.?? 400v voltage of generator... plz tell me with formula its urgent...plzzz... and also tell me that this 40 amp at all phases mean 40 amp on red,40 amp on yellow,40 amp on blue...... or the total sum of that 3phase is 40 amp....
which is better to use svc or synchronous condenser why ?
What is difference between potiential,volatge and emf
What is the use of conservater, bucchos relay, breather in a transformer?
8 Answers Bosch, Wipro, Zadco,
how to convert psi into kilo pascal? what is the suction pressure & discharge pressure of chiller?
in dc shunt motor if armature wdg is open then
what is differential relay in power transformer??
Why only 1ph,2ph,3ph supplies are universally used?? Why not 4ph or 5ph??
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)