Answer / sandeep vazhoor

Typical power circuit configuration involves 3 phase diode
rectifier at the input to convert the AC input to DC
voltage, LC or C filter to reduce the ripple in the DC
voltage. 3 phase IGBT inverter stage converts this DC
voltage into variable voltage variable frequency output as
per the desired pattern.

How much load can take a 16 mm aluminum cable 3 phase

0 Answers   L&T, Sanga Energy,

---

How much current will a 5 HP delta connected motor at no load will take?Is tat need a starter

2 Answers   GRB,

---

why we use Test Terminal Block in 11 KV and 33 KV electrical panels.

0 Answers   EMC,

---

'documenˁ

0 Answers  

---

what are fluorescent lamps (fluorescent fixtures) & what are incandescen lamps (incandescents fixtures) ? differences between these two ?

1 Answers  

---

why firewall is build up between two transformer (220/11kv,50MVA)?what should be the firewall height?what is the clearance between firewall and transformer?

2 Answers   Siemens, Tous Stadt,

---

What is the minimum insulation value required for a cable between phase to phase and phase to earth of 380 Vac 50Hz circuit, having load arround 800 amps.

2 Answers   DEWA, TATA,

---

what happens if i connect acapacitor to a generator load

5 Answers  

---

In an electrical conductor, if current flows because of flow of electrons, then why not the conductor gets thinner day by day???

1 Answers  

---

What is the winding resistsnce need to be in a 1000kva, 11kv/415v transformer, between ht winding to lt winding, ht winding to earth, lt winding to earth.?

1 Answers   Trident,

---

What is industrial automation ??????

5 Answers  

---

How do you find HT and LT sides of a distribution transformer only by looking at it from outside?

1 Answers   Nespak,

---