prove that inegration of { e^z / z^2 + pi^2 }dz is equal to i/pi by Cauchy Resi

prove that inegration of { e^z / z^2 + pi^2 }dz is equal to
i/pi by Cauchy Residue Theorem.

Question Posted / shovan chowdhury

1 Answers
3022 Views
I also Faced
E-Mail Answers

prove that inegration of { e^z / z^2 + pi^2 }dz is equal to i/pi by Cauchy Residue Theorem...

Then pi=3.14159... and i=sqrt(-1), I guess.I don't know if z
is a real or complex number and if there is a pole
somewhere.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

what is phase angle ? and also tells me why my phase-phase voltages are 390 rather then my single phase voltages are 221 and 223 respectivly?

2 Answers

I have 150/1A Rating CT Suppose if i inject 15A in CT " Secondary" means what will happen ??????

1 Answers

how a flip flop can be used as a latch?

0 Answers

What is the difference between earth fault protection of motor feeder with CBCT and Without CBCT ?

0 Answers Enmas, Michelin, Reliance,

How do i calculate sizing of transformer on didstrubution load for high rise building.What should be MVA Rating of MV Panel feding by 122 kv.

2 Answers

A commercial Building is designed with 14th floor levels with indoor substation of three phase transformer with rated capacity of 1000 Kva.The transformer delivered 65% of its rated capacity at 0.67 power factor lagging.Because of low power factor, the power customer was penalized and certain cost was charged accordingly based on every point percentage lower than 85%.This situation may repeatedly happen on the succeding energy bills of power customer.The power customer is desired to improve its historical power factor of 0.67 lagging and no further penalty be impose by the local power company on the next bill. Q: Identify the appropriate solution you want to offer to Client?.Justify SCIENTIFICALLY and MATHEMATICALLY the principles behind the solution.

0 Answers

Is electro plating what type of load whether resistive, inductive or capacitive loads

0 Answers Apollo,

The power dissipated by a resistor of 10ohm when a current of 2A passes through it is:(a) 0.4W(b) 20W(c) 40W(d) 200W

2 Answers

can we run all LT motors at 360 volts which are normally rated 415+/-10% voltage rating

2 Answers Meinhardt,

how much current does 3ph. 10 hp ac motor draw.

8 Answers

A 3 phase motor, 440 voltage, induction motor. If we take out rotor from motor and if we give supply 440 volt to stator then what happens?????

20 Answers

In pakistan appliances work on 220v at 50hz and in us appliances work on 110v at 60hz what is basic theory to explain it

1 Answers SNGPL,

For more Electrical Engineering Interview Questions Click Here