Answer / hassanelect

Fiber-Optic Thermometers:
These instruments enable near-infrared and visible radiation
to be transmitted around corners and away from hot,
hazardous environments to locations more suitable for the
electronics associated with contemporary radiation
thermometers. Fiber optics also makes possible measurements
in regions where access is restricted to larger instruments
and where large electric or radio frequency fields would
seriously affect an ordinary sensor. Conceptually, a
fiber-optic system differs from an ordinary IR thermometer
by the addition of a fiber-optic light guide, with or
without a lens. The optics of the light guide defines the
field of view of the instrument, while the optical
transmission properties of the fiber-optic elements form an
integral part of the thermometer spectral response.

Reference:
Process. Industrial Instrumentation & Control Handbook

Why do we floating DC in DC system.

0 Answers  

---

why we use condesiate parts before tranmitters?

3 Answers  

---

A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe

0 Answers  

---

generally transmitter power supply having some range(12v to 35v) but the out put(4-20 mA) must same for given input.If we vary the power supply voltage then output mA also to be change according to V=IR. Is there any voltage regulator in the transmitter ?

2 Answers  

---

SIR MAY I KNOW IF RADAR TYPE LEVEL TRANSMITTER SHOWING IN THE FIELD 0 % LEVEL AND IN DCS SHOWING 100% THEN WHAT IS THE CAUSE I CLEAN THE CHAMBER & TAKEN ONLINE BUT ONLY ONCE ITS BECOME ZERO IN DCS BUT AGAIN 100% SHOWING IN DCS,THEN I REMOVE THE POWER SUPLLY AND CONNECT IT AGAIN .IS IT OK BUT STILL IN THE DCS ITS 100% AND ON THE DISPLAY ITS INITILAZIATION PLEASE HELP ME READRING THIS?

4 Answers  

---

what is reset windup in integral control?

6 Answers   Honeywell,

---

Where we r using split range and ratio controller?

1 Answers   EID Parry,

---

1. For Steam drum level signal, why do we compensate with drum pressure signal? 2.For main steam Flow signal is comensated with main steam temperature signal and main steam pressure signal why?

0 Answers  

---

what is exact time to study dcs and plc cources

0 Answers  

---

EXPLAIN PROPOTIONAL INTEGRAL DERIVATIVE CONTROL ACTION?

1 Answers  

---

Why any transmitter signal is 4-20 mA only Why is started from lower range 4 mA and upper range is 20mA.

5 Answers   Edac,

---

how to measure oxygen which methods are using?

0 Answers  

---