Answer / ravishankar s.

The principle of Guided wave radar transmitter works on the principle of time and travel. Radar wave travels at the velocity of light. The flying time is converted into level signal via the electronic units. The probe emits high frequency wave pulses which travel along a cable probe or a rod probe.

you can easily understood like transmitter and receiver.

Answer / gamitsuresh

Gwr principle. Time domineering reflectrometry
The Pulses are travel guided with to process media when pulse reaches the surface of the material it is measuring differenc between

reflact to tx.and tx to surface of material time
It s convert to level

I want to measure flow by using DP Tx and range is 0 to 1200 Kg/cm2 ?

2 Answers  

---

Gas equation

0 Answers   CCIE,

---

What is the use of GMV in turbine?

0 Answers   Hamsco, Maruti Suzuki,

---

what are the problem's will accure in dcs or plc hadware and what are the solution for it?

2 Answers  

---

Regarding MOS (maintenance override switch), I want to know its function and its state ( 1 or 0 when not activated ). An example will be very helpful..thank you.

1 Answers  

---

How can I make calculation for Install level transmitter (DP) for open tank and cloes tank?

1 Answers   Petrofac,

---

What is difference between converter & transducers?

4 Answers  

---

kindly tell where orifice,nozzle,air foil,ventury used in flow measurement?

1 Answers  

---

How we will check whether the proximity, which we have is either NPN or PNP, if no data sheet or manual or any details is available to us ???

1 Answers  

---

Explain about SOURCING & SINKING concepts in PLC to field sensor wiring ?

4 Answers   GATE,

---

We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.

0 Answers   OPaL,

---

what is Potential free contact? where it is used?

3 Answers   Engineers India Limited,

---