Interested to Buy Any Domain ? << Click Here >> for more details...
Which buffer solution is used for PH transmitter
calibration?
- 3 Answers
- 6840 Views
- I also Faced
- E-Mail Answers
Answer Posted / srinivasan
we are using the 4.7 10.based on the configuration like 4 to
20 ma.if 4 ma means 0 and 20 ma means 10.when we using the
ph 10 it will get 20 ma..
| Is This Answer Correct ? | 2 Yes | 7 No |
Post New Answer View All Answers
what are the different types of Protocols? & their applications.
How to calibrate the flow transmitter
what is the procedure for auto tune in masoneialn 12300 series displacer type transmitter?
1.what is controller proportional gain 2.what is the controller intergral action time. 3.A proportional plus derivative controller that has a proportional band of 20% and a derivative action time of 0.1 minutes. Construct the shape of the output waveform for the triangular input if the input rises and falls at the rate of 4 units per minute.
steps for installing orifice plate?
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
How u measure the massflow in orifice flow measurement techniques
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
what is basic difference between motion balance and force balance in pneumatic instrument?
What are the maximum packet size of: a) HART b) Profibus DP c)Profibus PA d) DeviceNet e) Foundation Fieldbus
How do you identify between actual alarm and false alarm in a Temperature Transmitter in SCADA based Control System
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
I am manjunath having exp in maintenance of chemical plants,know i want to do a design course INTOOLS,after doing design course can we get jobs in design field.sinve i dont have design exp..
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
what is the procedure of O2 sensor(ABB) calibration?
