Which buffer solution is used for PH transmitter
calibration?
- 3 Answers
- 5889 Views
- I also Faced
- E-Mail Answers
Answer Posted / a.mondal
Phosphates buffer solution is used
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
what is RTV function in in process control?
what does it mean an active front end in vfd plz explain it briefly
Can any body tell me about SAP MAINTINANCE MODULE. WHAT IS its function and application. And study material Source about it. I shall be very thankful.
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
please any body have most important data for study for saudi aramco test of instrument QC thanks email shahnaveedullah@gmail.com
is there any digitel grevity meter availaible in the market by which we can measure specific gravity of a battery?
what is droop in governer ,type of droop ,how it work
how can leve transmetter calibate in feild .and also put cv and flow plz .....
what is isloted barrier how it works and what are the main purpose.how it make safe area.
why any measurement made interms of pressure is more accurate ? to be more precise most of the flow velocity is made interms of pressure and it is accurate. what is the reason behind pressure measurement being accurate ?
WHAT ARE THE INSTRUMENTAL DIAGRAMSOF VALVES?
our kks tagging is crossing more than 12 character please suggest how to take tags in the DCS
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
What are the uses of orifice plates?
