Answer / guest

VCB is batter than ACB.in hv side VCB is used & Lv side ACB is used current rapturing in vacuum is more effective than air

Answer / sanjeev

VCB Instal in HT side lower current & high voltage also HT
side instled ACB in stale in LT side high current upto
rating capacity lower volltage also used ACB LT side & VCB
HT side

Answer / arun pandey

It depends upon the application.
For lower voltage and current rating and at lower cost ACB
is better
and for heigher power rating VCB is better

Arun Pandey

Answer / farhan shaikh

acb is used upto LOW VOTAGE UPT 1kV AND VCB IS USED FOR HT
IN LIKE 3.3,6.6 kV

Answer / venkatesh s.r

Its depending upon application of usage.
VCB:It is using in HT side because of it will carry high
voltage &low current.
Example: in Ht side voltage is 11KV &current lee than 600
Amps

ACB:It is using in LT side because of it will carry high
current &low voltage.
Example: in LT side current is depending upon load &
voltage is 430 only.

Answer / jaimin

We are use ACB in LV system because of Low voltage & its
spark also low compare to HV system so that other
accessories use for ARC extinguisher size less than to HV
system.

But same system use in HV system need more size compare to
LV system for ARC extinguisher so we are use VCB design for
HV system & ACB design for lV system, All are suitable as
per respectively.

Answer / ashoke

V.C.B. is best for H.T. and A.C.B. is best for LT(Up to 300
Amps.max.)

where to use 3.5 core and 4 core cables, will this vary for type of loads

1 Answers   KSBC, Medreich,

how many types of ratings are there of transformer

5 Answers   Met Trade,

What is the basic difference among IPS,UPS,EPS?

2 Answers   ABB, Navana,

how to reduce the magnetizing current in distribution transformers

1 Answers  

I need a formula to calculate the size of cable as per load but in the terms of length. Please Reply me as i search lot of sites but i did not get the answer.

0 Answers  

BRIEFELY EXPLAIN MEGGAR PRINCIPLE

2 Answers  

A 6.6 KV/ 440V Xformer. what are the imporatant parts & equipment required for it's protection panel.

0 Answers   APTransco,

How can ignition voltage of light increased with the help of a ballast

1 Answers  

2. Modify your design in question 1.a so that the circuit works according to the following function table X Y F 0 0 Clear 0 1 No Change 1 0 Parallel Loading 1 1 Count 3. Design a circuit that detects the pattern 010 in a serial input X considering: 3.a Overlapping 3.b No overlapping

0 Answers  

how to calculate capacitor rating for an induction transformer ex.for 12 mva furnace calculate capacitor rating

2 Answers  

can a 12v dg starting battery(150 AH) be replace by 6 nos of 200AH batteries each of 2v connected in series.

3 Answers  

To check the earth condition (In plug points); the voltage between earth and Neutral is in below 5 volts. Is it correct

6 Answers