specific difference of ICT&Auto Transformer
No Answer is Posted For this Question
Be the First to Post Answer
Pl. share your experience about industrial-electronics repair of machine tool.
How to select HT/MV cable size ?
which motor used in electric train ans how much volt.
what will happen if earth of 33 kv cable (earthed system) is not connected to earthing pit?
What is multiplying factor of meter if the meter ctr and ptr is open type?
What is the ohms law?
How to take Transformer oil Break down voltage test?
What is the actual formula for transformer short circuit test? below i given rating of the transformer.. 1000KVA, pri 11KV, Pri amp 56A. %Z 5.95..
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT SWITCH BOARD,MLDB,ACB,BUSBAR,ETC...?
why generaotr rating is in kva and dc motor in kw?
The armature of shunt dc motor has 0.8ohm resistance and motor is to run on 120V circuit.If motor is suddenly thrown on circuit while armature at standstill then current drawn by motor will be??Also back emf in normal running is 110V
Why ACB is used in LT why not in HT and why VCB is used in HT why not in LT
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)