What is the basic principle of vibration measurement by
BENTLY NEVADA vibration measurement system? and Why it
gives the -ve voltage output?

Answers were Sorted based on User's Feedback



What is the basic principle of vibration measurement by BENTLY NEVADA vibration measurement system..

Answer / velu

thanks mr.steve.
doubt from long time now it is clear

Is This Answer Correct ?    2 Yes 0 No

What is the basic principle of vibration measurement by BENTLY NEVADA vibration measurement system..

Answer / noel

Thanks a lot Steve Sabin.
I was facing the same doubt from long time. I guess coil
converts impidance to voltage by resonance principle. and
it uses -ve resonance.. PNP transisters are used to
generate excitation frequency..

Is This Answer Correct ?    10 Yes 10 No

What is the basic principle of vibration measurement by BENTLY NEVADA vibration measurement system..

Answer / liji

Thanks Steve..Very clearly mentioned

Is This Answer Correct ?    1 Yes 1 No

What is the basic principle of vibration measurement by BENTLY NEVADA vibration measurement system..

Answer / $h@@mi

thanks steve

Is This Answer Correct ?    1 Yes 1 No

Post New Answer

More Instrumentation Interview Questions

warning lamp does not light, but it does light when the wire from the lamp going to the sending unit is grounded (the part that plugs into the sending unit) what does this indicate)?

1 Answers  


Speedtronic system .

1 Answers   CCIE,


Ohm’s law, kirchoff’s law, pascal’s law, Bernoulli’s therem,

1 Answers   CCIE, Emcure,


What is the diffrence between digital signal processing and discrete signal processing?

1 Answers  


What is the difference between fiber optic cable & Ethernet cable

2 Answers   BEMCO, CCC, Pidilite,


EXPLAIN SOME IMP QUESTIONS AND ANSWERS ON TOPIC ELECTRONICS,INSTRUMENTATION.........

1 Answers   ONGC,


capillary type tranmitter using remote seals and capillary tubes filled with liquid of known of known density so if you wanna callibrate it just close block valve just before capilary @ high side & connect druck apply it's calibrated range pressure as normal calibration ensure low side block valve must be closed & if you asking commissioning so this is not a DP type pressure tx so simple if you wanna put in servie this tx just open high side block valve & than low side block same way i do it but still transmitter showing -13 ma.just tell me what i want to do ?

1 Answers   Gasco,


send me HPCL paper

7 Answers   HPCL, Shuiba Hotel,


hi... i'm about to learn siemens plc i came across following question in my mind ... plr ans 1. hw motor operated by plc 2. hw drive operated by plc explain dis by both ladder logic diagram and hardware config , connection

2 Answers   KCP Cements,


List three types Level Gauges with their working principles

1 Answers   ABB,


What is the relationship between the universal gravitational constant (G) and the acceleration due to gravity (g)?

3 Answers   APPSC,


Controller not working in auto mode?...what are the problem can occur...Pls explain

1 Answers   Aramco,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5086)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4453)
  • Electrical Engineering Interview Questions Electrical Engineering (16638)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)