Interested to Buy Any Domain ? << Click Here >> for more details...
What is the basic principle of vibration measurement by
BENTLY NEVADA vibration measurement system? and Why it
gives the -ve voltage output?
- 14 Answers
- 135523 Views
- Ensol, GNFC, Reliance, Siemens, I also Faced
- E-Mail Answers
Answer Posted / noel
Thanks a lot Steve Sabin.
I was facing the same doubt from long time. I guess coil
converts impidance to voltage by resonance principle. and
it uses -ve resonance.. PNP transisters are used to
generate excitation frequency..
| Is This Answer Correct ? | 10 Yes | 10 No |
Post New Answer View All Answers
What is the Working principle of Dozing valve?
What is rang ability?
what is wave length were using ?
In most instances, Inertia processes are quite uncommon. Give an example of a combined Resistance and Capacitance situation.Describe an application, which according to your understanding of the subject matter, comprises of both Resistance and Capacitance effects.
what is the minimum power (P=VI)to produce a spark?
what is the difference between Cv and air consumption? why the customer needs Air consumption details?
Describe the functions of the Operator Interface including the considerations related to alarming and display layout/configuration/layers.
my data card only does run in my mobile so how can change it that it run other mobile & computer and i can stor data in my data card
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
Why do you want to work here
sir, give me placement papers and interview quistion of birla group company of copper.
this site is owned by an nonsense
In Safe Guarding test what means by "Failed to Danger" ?
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
