What is the basic principle of vibration measurement by
BENTLY NEVADA vibration measurement system? and Why it
gives the -ve voltage output?
- 14 Answers
- 135919 Views
- Ensol, GNFC, Reliance, Siemens, I also Faced
- E-Mail Answers
Answer Posted / velu
thanks mr.steve.
doubt from long time now it is clear
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
plz send me general of ongc
principle of dead weight tester ?
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
hye SAM acn u send your e mail id, so that i can solve my query through e mail?
Questions on flow meters,few questions on HART protocol,
use of split range ? where it is used ? in which control loop it is used ?
give me all the details about the interview and which type of question being asked
I WANT SECURITY PAPER MILL, HOSHANGABAD TEST PAPER.KINDLY SEND TO MY MAIL ID
Punj lloyd is coming in our Jadavpur Universtiy campus for campus placement. Please send me some hints about the writtend exam. My email id is subratafriends@gmail.com
send me last 5 years questions asked in rrb chennai, for section engineer
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Can any one tell me what type of question asked for instrumentation and control interview panel??? pls mail ramashankar.goel@gmail.com
Can any body help to get Rsemulator 5000 free from internet if possible then give me any link or any help .
sir i m preparing for BARC but i am not getting any papers to prepare for this exam so please send me some sample papers to my i.d for the preparation of barc.
plz you help about Que paper of mahagenco previous your,any model paper relad to it{maharastra power genration}
