Answer / balu

There are two CT output current. 5A or 1A. These are
standard outputs.There many measuring and protective
instruments will be connected to this secondary. So these
instruments designed for the output of this current. Based
on the customer primary current, the multiple factor can be
programmed to measure primary current. So, it reduces
customization .

Answer / ashish gupta

It consider to be standard. But if we see the ratio error and phase angle error formula we observe that turns ratio ns comes out to be in denominator.So higher the turns ratio lower is the error. So higher turns ratio is obtained when secondry current is 1 amp

Answer / mukhesh

bec from t/f see relese the cts primary curent and
transfoemer ratio will give the exact 5a if any fault o
tr line the ratio willt if open will burnt ou be other
than 5 a ansd seec should not open at any time

Is motor current is dependent on load.

2 Answers  

---

electrical

0 Answers   BSES, Minda,

---

how can we can take BDV test in transformer?

5 Answers  

---

If two generator running parallel, at that condition both ngr Taken in line or taken any one ngr, but why any one or both Ngr in line? Ngr is use for which purpose?

3 Answers  

---

draw vector diagram and +ve,zero sequence diagram of symmetrical three phase fault.

0 Answers  

---

Define stepper motor. What is the use of stepper motor?

0 Answers  

---

why we r not earthed Control cable of C.T. terminals

0 Answers   HCC,

---

What is the use of starter in tube light fitting.how it works.

3 Answers   JSW,

---

Define characteristics impedance?

0 Answers  

---

how the vaccum ckt breaker workes..? how the arc is quenching in it?

1 Answers  

---

how i run d.c. moter with solar panel without use of battery?

1 Answers  

---

what is smart&micro grid technology?under coal gassification?

0 Answers  

---