Answer / Hemant Bhardwaj

Electrical engineering is a branch of engineering that deals with the study, design, and application of electricity, electronics, and electromagnetism. It encompasses various areas such as power systems, control systems, telecommunications, signal processing, and electronics.

how can i find ct ratio of meter by seeing name plate of meter and how it should be used in MF calculation if it shows only-/1???

1 Answers   Harshal Electrical,

---

How many types of interlocking use in screw type air compressor,make-Kaser(BSD MODEL)?

1 Answers   Automobile, Siddhi Vinayak,

---

kindly tell me how the load on generator increase by just increasing the fuel of prime mover, as if for exampple 20 MW gen set is synchronized the load ramps from zero to 20 MW gradully and during this procress only fuel of prime mover increases. Which thing determines the load on generator with respect to fuel

4 Answers   Birla,

---

which starter is used for synchronous motor

18 Answers   APTransco, IBM,

---

why rating of transformer is in KVA but of motor is in KW

4 Answers  

---

what is the acceptable limit value for Desolve Gas Analysis/

1 Answers  

---

what is the difference between scaler and vector control in drive and where it is to be used ?

1 Answers   Essar, TCS,

---

What is q factor?

1 Answers  

---

why dont we use the same pylon to carry 400 kv plus 220kv and 33 kv ?

2 Answers   Focus, Focus Energy,

---

Sparking occur when a load is switched off because the circuit has high – a.) Inductance b.) Capacitance c.) Resistance d.) None

3 Answers   Ecil,

---

Disadventage of cable-gland earthing if any ?

1 Answers  

---

when the time of backcharging the transformer three phases only enough or three phase with neutral is must.from these which one is the best one.

1 Answers  

---