Interested to Buy Any Domain ? << Click Here >> for more details...
why CT output is always raetd 5.regardsof primery curre.
- 3 Answers
- 7197 Views
- ABB, BARC, I also Faced
- E-Mail Answers
Answer Posted / ashish gupta
It consider to be standard. But if we see the ratio error and phase angle error formula we observe that turns ratio ns comes out to be in denominator.So higher the turns ratio lower is the error. So higher turns ratio is obtained when secondry current is 1 amp
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what kn of disc is used in 33kv,132kv,220kv,400kv,800kv transmission line
Hi all I had applied for the RRB test in the ELECRICAL category. I would be pleased if any of you can sent me previous year question papers. Please forward the question papers to varshashahi@yahoo.com Thanks and regards Varsha
why we change the direction of winding in rotor ?how we make the north and south pole?
What is trip and closing coil in cb? Why need of them
In diesel generator how AVR get voltage to excitation. And basic diagram DG EXCITATION CIRCUIT.
why we have to particulary use ACB for below ratings,even available of MCB,MCCB with that range ?
Can any body tell me the different types of LT cables & their application.
In what cases (circumstances)we should apply P controller, PD controller, PI controller & PID controller ?
what is resver in electrical enginnering with answer
What is thresh hold value of current?
What is the difference between isolators and electrical circuit breakers? What is bus-bar?
Is it required to do earthing in 2nd shop if earthed armoured cable is laid from 1st shop ?
Why water bubbles when D.C. Current is passed through it? Why not when A.C. Current is passed?
Is there any rule to select the voltage of motor based on KW rating? What is the rating above which lt motor becomes the HT motor?.
what is meant by star/delta voltages as 440/220 in a 3 phase induction motor, and why it should be connected on STAR IN 3 PHASE SUPPLY
