Answer / vg

yes,the current is always dependend on the load.

Answer / mahesh joshi

yes if load will increase than current will increase

why can not run two different phase circuit in to the same conduite

1 Answers  

---

In a 3 phase 4-wire system. For a 3.5 core cable if all loads are single phase and balanced, what will be neutral current? will it be sum of all phase currents? Or it will be zero? And if loads are unbalanced what will be neutral current?

0 Answers  

---

What is servo Motor? What's the advantages of this motor over Induction motor?

1 Answers   Amtek,

---

what happen when power factor of 2 parallely operated transformer become equle?

0 Answers   Flextronics,

---

What is the permissible value of earth resistance!

11 Answers   Torrent Power,

---



0 Answers   TATA,

---

Why the electron flow in reverse of current.

6 Answers  

---

What is the harm if we install primary side 11 KV VCB at a distance of one Km from the 11/3.3KV 12.5 MVA transformer through 11 KV cable.

4 Answers  

---

Why induction motor overheated?

2 Answers   HVCC, Physical Research Laboratory (PRL),

---

i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.

0 Answers   SCM,

---

in the farm,water tank of 8000 litter capacity situated in 12 meter above.Farm owner want to lift 7000 litter of water within 7 minute to water tank of 12 meter above.which motor having HP rating is suitable for pumping??

1 Answers   ABB, Anchor, Havells, Keltron, KSEB, L&T, vguard,

---

While HT line put on to activate ACB in low tention panel VCB tripping instantly.why it happens

0 Answers   Engineering,

---