Answer / nishad

for the protection of generator we useing
1, under voltage/ overvoltage Relay
2Under/over frequency,
3, Reverse power relay,
4, Earth fault Relay
5, Differential Protection relay
6, over load protection
8, resticted earth fault relay ***(optional)
9,RTD's for bearing & winding >> protect from over heat
10,if it contain in clossed container provide differential
pressure relay,
These are the normal protection from Electrical side.

Answer / hitesh g. dobariya

The following are the main protection schemes adopted for
our generator.
1. Generator Differential Protection
2. Generator & Transformer Differential Protection
3. Loss of Field or Loss of Excitation Protection
4. Negative Sequence or Current Unbalance Protection
5. Over Fluxing or Over Excitation Protection
6. Over Current Protection
7. Stator Earth Fault Protection
8. Rotor Earth Fault Protection (64R)
9. Restricted Earth Fault Protection
10. Backup Impedance Protection
11. Low Forward Power Protection
12. Reverse Power Protection
13. Pole Slip Protection
14. Pole Discrepancy Protection
15. Local Breaker Back Protection
16. Bus Bar Protection
17. Over Frequency Protection
18. Under Frequency Protection
19. Over Voltage Protection

Answer / renjith v.r

The following are to be used
1.Voltage restraint O/C relay
2. E/F relay
3. stand by E/F relay using CT in neutral earthing conductor
4. Under voltage ,over voltage relay
5. Differential potential relay
6.negative sequence relay
7.Vector surge relay
8.Reverse power and Reverse reactive power relay
9.rotor E/F relay
9.High vibration, oil temperature, Overspeeed and under speed alarm trip

Answer / vedprakash uppadhaya

reactors, thyristor contoroled rectifier

Answer / venkat

brushes

what is laser diodes?

0 Answers  

why we r used DC megger insted of AC megger?

1 Answers   Adani,

10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)

0 Answers   CTS, Jindal,

How to determine earth fault level to set relay for a normal distribution system of 11 kV , 100 A load????????

1 Answers   TCS,

why plc need seprate earthing?

2 Answers   ABB, Whirlpool,

Briefly describe three methods that are usually used by electricity suppliers to control voltage levels?

0 Answers  

Mention what are the types of semi-conductors?

0 Answers  

Iwould like to know barc interview questions

0 Answers   BARC,

how can we convert 48V dc into 12 V dc? Any standard device for it??

2 Answers  

What is Control & Relay Panel? And Remote Control Center?

0 Answers   L&T,

why knee point voltage should be high in Ct for differential protection

1 Answers   NTPC,

What is double throw isolator and single throw Isolator.

1 Answers   KSEB, L&T, Siemens,