Answer / nagaraj n salimani

Power factor depends on the connected load on that perticular
phase due to heavy inductive load ( Induction motor)but you
are telling it is different in all three phase it is due to
the mismatch in the phase impedence in the motor winding

Answer / ramarpandi

inductive load

what will be happened when a single phase motor is supplied by the dc supply

3 Answers  

---

What descriptive information does the NEC require to be marked on all conductors?

0 Answers  

---

wat is the difference between real power and reactive power..which is useful..?and how it s useful..wat is the effect of these on a power system...

10 Answers   ABB,

---

1.Why hydrogen used for cooling in generators 2.Why electrical equipment protected by ground 3.Why earthing for transmission line 4.What is rms value of half wave rectified square wave. If Rms value of actual wave 2amps.

1 Answers   Power Grid,

---

what is the difference between id fans and fd fans

12 Answers   Perkins Thermal Systems,

---

What is the use of starter in tube light fitting.how it works.

3 Answers   JSW,

---

what is rating providing of contactor,relay,fuse unit for motor output power

2 Answers  

---

What is C curve and D curve of MCB?

3 Answers   GMR,

---

Can I use cable armour as a earth conductor? if not how many GI/CU wires I need to run along with cable?

1 Answers  

---

What is the difference between RCD & RCCB, Where it can be used

3 Answers  

---

WHY DISEL GENRATOR SET SHUT DOWN IN OVER LOAD CONDITIONS

5 Answers   HMT,

---

400 kvtransmission lines in india are connected in star or delta

10 Answers   NTPC,

---