As per BIS, Earth pit resistence value?

Question Posted / johnringson

4 Answers
9488 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

As per BIS, Earth pit resistence value?..

Answer / johnringson

Below 1 ohm.

Is This Answer Correct ?

10 Yes

1 No

As per BIS, Earth pit resistence value?..

Answer / ramdarkmaster

Earth's resistance will differ from place to place....
it all depend's on soil resistivity... some places it may be red soil, were as in some places it may black cotton soil..
so we need to measure the resistance using earth tester..
but normally it will in few ohms.

Is This Answer Correct ?

7 Yes

4 No

As per BIS, Earth pit resistence value?..

Answer / mukesh kumar

Copper earthing should be below 1 and GI Earthing below 3.

Is This Answer Correct ?

5 Yes

4 No

As per BIS, Earth pit resistence value?..

Answer / rajesh pal

Value of earthing G.I should be minimun <3 ohm this value we can use for body earth any machine D.G ,Transformer any other
and copper earth value shoul be < 1 ohm it will bettor for Nutruel earth for D.G and transformer and also connect with isolation transformer and some medical machines MRI, CT scan,kottery machine OT and other machine which require.

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

which type of amplifiers are used in multimete?

0 Answers NTPC,

Explain Analog and Digital signals?

1 Answers UOG,

What is Load commutation and how it is done?Cite some example where this type of commutation is used

2 Answers NTPC,

HOW MUCH MAXIMUM CURRENT TAKEN BY NEAUTRAL IN 125 KVA DG SET

1 Answers KOC,

Is there any other method of damping the oscillation in a synchronous motor other than using damper winding and if yes what is it?

2 Answers IOCL,

what is the difference between vector scale and vector diagram?

1 Answers

what do u understand about FACTS? how they are useful?

0 Answers BARC,

what is the use of sdf?

0 Answers Areva, SWAN,

what is reactive and active power?why we need power factor correction?

2 Answers

When One Phase PT Missing (voltage drop ) this time current is zero of This phase(PT Missing Phase) and current is Not Zero of other Phase but PF is always Low That Why

0 Answers HCL,

We have laid the single core Armoured cable 7 nos ( 2 each phase & 1 neutral ) to cater our electrical load . the issue is though we have Glanded the cable both the end also givan the earthing to the panel both the end we are facing a heavy sparking at the gland side. what could be the reason.

12 Answers

what is rating boiler

0 Answers

For more Electrical Engineering Interview Questions Click Here