Answer / vasudevan

DC has zero frequency. Hence, if DC is supplied then XL
will become zero. That is winding reactance is zero. Hence
winding gets short circuited and they will be burnt
immediately. It may cause severe explosive also.

Answer / sivakumarbsk

winding may burn

Answer / rajasekhar

first of all for an ac motor there must be some alternating
flux if it is constant flux e=0, infinite currn flow

Answer / raja

When dc supply given to the ac motor then it has no rotating
magnetic field so when there is no rotating magnetic field
present in the secondary winding so motor does not rotate,
and primary winding may be damaged due to short cercuit.

Answer / bharath kumar

if dc supply is given to the ac motor as the dc has no
negative cycle and no frequency the reactance part becomes
zero that is XL=0 then there is no winding resistance hence
the winding may burn and the motor may damage

Answer / ajoy boishya

If dc current is supplied to ad motor then the ac motor will move in a to and fro motion the reason behind this is that ac motor has a pair of slip rings which don't change the direction of the current . Hence after on rotation the current through the solenoid will get reversed causing it to turn reverse.

Answer / sree

if dc supply is given to ac motor it will work with less effeciency and sparking at the brushes.
in order to overcome the draw backs we found the ac series motor called universal motor.
universal motor app;trimmer mixiers ,small hp machines

Answer / baisakhi ghosh

as there is no change in current ,flux is constant.so no
back emf

Answer / dfg

dfgdsf

highest rating of alternator used in india

1 Answers  

How can identify meter AC or DC without use of symbel?

4 Answers  

What is the difference between single core 2 wire and single core 3 wire system? Which application we are using this? and for What purpose we are using this?

0 Answers  

how to calculate short circuit calculation of the transformer by usuing the percentage impedence? formula needed.

2 Answers   L&T,

What is I to C?

0 Answers   PowerTech,

In what voltage EHT works(133/132/33/66kv?

3 Answers   Adhunik,

in a transmission line if the load is suddenly increased in the receiving end of the system the phase shift will ?

1 Answers  

Do you know how to connect a motor of different H.Ps?

5 Answers  

what is relation between vector group of transformer and its load hormonics?

1 Answers   Sanmar,

sir i applied for hpcl(electrical).i want to know from which subjects most of the technical que will b asked.and pattern of the written test.pls help me

0 Answers   HPCL,

why dc did not flows to earth?

2 Answers  

explain why tap changer is always connected to high voltage winding side of the transformer.

10 Answers   IOCL, UPPCL,