what are feeder pillars & panels?
Answer / amarnath
Feeder pillars are the breaker panels which is the very
first set of switching/protection device at the
output/secondary side of the transformer and panel board is
a set of switching/protection devices used for distribution
of power supply.
Is This Answer Correct ? | 47 Yes | 13 No |
dear all, in motor operation , motor is of 100 hp and bimetal relay setting is 130 amp, if relay is getting tripped on 120 amp balance current what can be the reason? Relay is newly replaced. I dont know but is there any frequency effect in thit case? Can frequency variation affect bimetal relay operation?
if the stetor speed (N S) increase by 20% then the rotor speed will be increased by 20% is it true. ?
Magnetizing current for induction motor compared to transformer is= A equal B more C less D depends on load
What is the efficiency during maximum power transfer?
why when i start my diesel generator it takes 1 minute or less then stop, and i checked the oil sensor is ok and when the generator start i can get 220 voltage but it it is stop after 1 minute or less, how can i solve this problem?
what are the types of electromagnetic forces developed in practical transformer?
0 Answers APC, BPCL Bharat Petroleum, Electrical Tech,
why do select 11000v rubber mat even we use only 415Volts
1 Answers Saint Gobain, Tata Steel Limited,
Where can i get practical knowledge of solar system?
what is the radio of kva & kvar or why calculated kva & kvar
how the capacitor work on dc?
how the reverse power relay acts..
What is lighting kitts.