what will happen to give a dc supply in transformers?

Question Posted / m.hariharan.

3 Answers
6469 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

what will happen to give a dc supply in transformers?..

Answer / mahesh sali

dc supply given to the x'mer , there is no flux produced
into the transformer due to the absence of frequency ,
cause will be damaged of insulation of x'mer and its get
overheated

Is This Answer Correct ?

10 Yes

0 No

what will happen to give a dc supply in transformers?..

Answer / naveen

it will lead to burning of transfotmer because there will
not be any secondary emf hence tranformer will work like a
load itself & due to overheating it will burn.

Is This Answer Correct ?

0 Yes

0 No

what will happen to give a dc supply in transformers?..

Answer / guest

When DC is supplied to a transformer the windings in the transformer will make it a electro magnet. There will be no
effect on the secondary but when the supply is interrupted a
voltage will be induced in the secondary.

Is This Answer Correct ?

0 Yes

5 No

Post New Answer

More Electrical Engineering Interview Questions

We have a bank capacitor rating of 60 KVAR for a overall load of 160 KVA and we have connected three loads of 50KVA each. We would like to auto matically correct PF using APFC. How do we design it?

2 Answers

There are 2 Flip_Flop with logic between them. Given Clock to Q delay, logic prop. delay, set up and hold times specify maximum clock frequency of system. What happens if second output fed back to first input. Any changes? What happens with timing if second output is fed back to logic between the flops? Good Luck!

1 Answers Qualcomm,

What will be done if we open the secondary of CT on load??

4 Answers Engro,

before synchronizing an alternator,power factor is leading ,why?

0 Answers CUMI,

how can we calculate the ratio of caustic soda and water in lrs.

0 Answers

where does 22kv line starts

0 Answers Eskom,

why circuit breaker closing time is always higher then tripping / opening time.

13 Answers United Phosphorus,

What is the dependency of stiffness on load angle??

0 Answers

Can we use a absolute encoder to show rpm of a motor ? what about the condition when power is off ? what is difference if a incremental one is used ?abanirout@gmail.com

0 Answers

raleigh method

0 Answers

what is the change over switch ,switch disconnector ,bypass switch and switch disconnector fuse unit?

1 Answers

Hi all I had applied for the RRB test in the ELECRICAL category. I would be pleased if any of you can sent me previous year question papers. Please forward the question papers to varshashahi@yahoo.com Thanks and regards Varsha

0 Answers

For more Electrical Engineering Interview Questions Click Here