Follow Our FB Page << CircleMedia.in >> for Daily Laughter. We Post Funny, Viral, Comedy Videos, Memes, Vines...


why not feeling shock while touching rotor shaft of
induction motor during running condition? during running
condition emf induced in rotor.



why not feeling shock while touching rotor shaft of induction motor during running condition? duri..

Answer / mahavir jagdev

the rotor winding is insulated, apart from the rotor shaft being earthed through the motor body.

Is This Answer Correct ?    2 Yes 5 No

Post New Answer

More Electrical Engineering Interview Questions

what is the difference between KVAR & KVA ?

11 Answers   Bombay Rayon Fashions, Hyundai, Pricol,


what will happen if the connections of protection ct reverse? will it burn the ct?

2 Answers  


How to calculate cable size in sq units based on motor rating is KW

2 Answers  


In ac motor,when dc supply is given what happend to the motor?

3 Answers  


Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.

0 Answers   HAL,






what is the maximum load in MDB,SMDB and DB

1 Answers  


What is difference between Over Current & Earth Fault protection?

0 Answers   ABC,


what are the effects of variations in frequency when you are connected to national grid??

1 Answers  


when we switch on the switch and load is not connected at home,is electricity wasted?

1 Answers  


Why in India only 50hz frequency not 60hz

2 Answers   Prism Cement,


What is the acceptance value of leakage current in HI POT test

2 Answers   CPCL,


why is power supplied in 3 phase only? why not in 2 or 4 phases?

11 Answers  






Categories
  • Civil Engineering Interview Questions Civil Engineering (5076)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4445)
  • Electrical Engineering Interview Questions Electrical Engineering (16606)
  • Electronics Communications Interview Questions Electronics Communications (3915)
  • Chemical Engineering Interview Questions Chemical Engineering (1092)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (214)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (258)
  • Instrumentation Interview Questions Instrumentation (2992)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (123)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (0)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1378)