In transformers Which type of connection is preferred for harmonics to be minimum. primary : secondary star without neutral:open delta star with neutral :open delta star without neutral: delta star with neutral : delta explain why
1 3388Why one can experience electrical Shock due to Voltage or Current?? or both voltage or current??
11 9223Which pump set is more suitable and economical for liftingwater from 300Mtr borewell? A. Compressor Pump B. Submersible Pump C. Jet Pumps D. 25HP Centrifugal Pump Q. from PSC Test 22-11-2008 Meter reader
8 19374Post New Electrical Engineering Questions
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
how does the terminal voltage of transmission lines increase when a capacitor is connected???? This happens not only in transmission lines but also in all circuits. How??? When a capacitor is connected in a transmission line, capacitor also takes energy from the same supply. But how is it able to increase the terminal voltage??? Practically What sequence of events happen during increase in voltage???
What happen when neutral point connected to core balance current transformer? (Neutral point of an alternator of a 180KVA DG. Neutral point connected to CBCT means enter to the CBCT)
What Is HO factor in power selection
what is the relative size of single and three phase?
What can you contribute to the progress of our Company as an employee if you are selected?
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
Difference between HRG and NGR. Are they both the same thing
r we are using in gas turbine mark (5) frame (6) (made in india Bhel 1997) Ā
What are the different methodes for calculating the short circuit Current?
what is the AC Plant and how can do the work with parts and picture tell us 150 Tr
Two electric lamps 40 W, 220 V each are connected in series across 220 V. What is the power consumed by the connection?
what is th basic difference between a d latch time line and a d flip flop time line???
- two pumps must work with them at the same time but if the first pump start the second pump must delayed for some time to start also , with motor rated power = 90 KW and rated voltage = 380 V and rated power factor = 0.85 lag please draw the power and control circuit for it and determine all circuit components parameters that you use it
Explain how you intend to work under pressure to meet up with deadline target?
