Which pump set is more suitable and economical for
liftingwater from 300Mtr borewell?
A. Compressor Pump
B. Submersible Pump
C. Jet Pumps
D. 25HP Centrifugal Pump
Q. from PSC Test 22-11-2008 Meter reader
Answers were Sorted based on User's Feedback
Answer / h nayak
Hi friends,
Submersible Pump is suitable for lifting the water from 300
ffet depth.
| Is This Answer Correct ? | 7 Yes | 1 No |
Answer / puneet singla
submersible pumps are more suitable for lifting water these submersible have different models which is to be installed at the location also installations is depend upon the connections type and according to water needs. if there are 5acre of lad and connection is of 25hp than 25 hp 8 stage v8model is highly suitable which give 850 ltr approx a minute
| Is This Answer Correct ? | 2 Yes | 1 No |
Answer / raj
subersible pump & 25 HP centrifugal pump are more suitable
and economical for lifting water from 300 meter borewell.
| Is This Answer Correct ? | 5 Yes | 5 No |
Answer / sidhu.k
hi, above all the guys are given answers not fully
satishfied ,as per my knowledge see water lifting is depend
upon the capacity of the motor, and pump stages,15hp 28
stage submursible motor is sufficient for 300mtr depth
water lifting .i dont no purpect formula , but it is to be
allready done in my practical life. 1 stage = 35ft.ok,any
body have formula to caculate this please send
immidietely.thanks to all friends.
| Is This Answer Correct ? | 1 Yes | 2 No |
Answer / harikrishna
hi friend this is harikrishna from hyderabad
I think jet pump is suitable for lifting the water from 300
ffet depth.
| Is This Answer Correct ? | 3 Yes | 5 No |
Answer / ahmed
25 HP CENTRIFUGAL PUMP IS ECONOMICAL FOR LIFTING WATER OF
300Mtr BOREWELL.
| Is This Answer Correct ? | 1 Yes | 4 No |
what is SWA type of cable?????
why is the power generator connected as star earthed or star earthed through reactance and what its features ?
in ceiling fan and table fan what is the rotating part and what is the stationary part?
Why motor initial starting current is high?
What is the purpose of stablization resistor in high impedance bus bar protection
what happen if i connect DYn11 and DYn1 vector group transformer in parrallel?other things are same like votage ration,x/r ratiob etc...
In Single Phase AC Supply,If Voltage between Phase and Neutral is 230V means what will be the Voltage between Phase and Earth?
what is the safty of poly phase tranformer?
what is the operating principle of contactor(power).along with disection?
3 Answers NASA, Tech Mahindra,
why AC signals are represented by sinusoidal waveform?WHY other waveforms not used for representation
harmonics filter
If we have to find the inductance of a dc shunt motor then by giving dc supply or ac supply and what is the reason for it. (this example is from "to determine the transfer function of a dc shunt motor ")
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)