what is the reasson after complition of suction stroke and started compression stroke inlet valve open for few digrees
TATA,
4 6239in power plant lube oil system, if oil mist/vapour eliminator is not running what are all the consequences occur in system?
TATA,
1 3323what is ERW PIPE & Seamless PIPE Out of ERW and Seamless which one gives good results for an impact force of 2700 N??
NTPC,
2 6697
What will be the current drawn by HT motor, if low voltage is applied.. any formula to calculate the LT amps of HT motor.?
What is MS-EXCELL?
1m square 20mm plastering how much of water need curing work
How much qty of stone ; sand; cement in R/R stone masonry of 136 CUM
why you don not show protection and type of isolation in key single line diagram?
Efficient electrical earthing in hard rock area
why does bitumen heated from top side bt not from bottom side€
if any one who attended the caterpillar interview please send me the sample questions and the areas from which questions are being asked...
why unix commands simpler rather than complex task
Is the installation of the filter cloths necessary before spreading the gravels at the transformer yards?
What is the density of DLC & PQC and how it is differ from normal concrete?
What is the formula of frequency ?
How can I make calculation to Install level transmitter (DP) for open tank and close tank
Typically, an IA has an external resistor used for A Establishing the output impedance B Setting the voltage gain C Setting the current gain D Interfacing with an instrument
What is compound gage