Interested to Buy Any Domain ? << Click Here >> for more details...
-
Civil Engineering (5086) - Mechanical Engineering (4456)
- Electrical Engineering (16639)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
if we mount flow tube in arrow direction then flow comes in negative & if we mount it another direction then flow comes positive,So what will be the problem
2 4883How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke
2096what will be the cement and sand needed for 1sqm plastering ? for ratio 1:6 and 10mm thick
HLL,
4 9896Dear sir,We have a 7.5hp motor,it was running smoothly and suddenly one winding is carring more current then others(r=6.5,y=6.3,b=10)..whts wrong with tis...?
5 8380What happens if we give the supply to the rotor of induction motor and make its terminal shorted?
2 4074
i have install 750 kva distribution transformer at my site and want to do neutral earthing. what calculations should i follow to determine earthing conductor material and size?
03. a. The water cement ratio for achieving maximum strength of concrete is…… 1 b. Water/ cement is inversely proportional to-------------- 1 c. Increasing the slump decreases the strength: True / false 1
sir i have 4 year gap in engineering. i would complete my degree b.tech it in 2014. it will be may be in 2nd class.my hsc is also with 2nd class. i am week in programming. Then if i want highest package upto 5-6 lacs then what should i prepare myself as a good engineer to get this package???
How to decide DO set rating of Transformer?
What is the minimum temperature for stress relieving of astm a 519 gr.4130 material and please tell us where we can find the location.
can dp type level transmitter work in under vaccum condition
can we create an interrupt in plc through scada?
What is a feedback? And explain different types of feedback.
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
what size shaft is required to transmit 100 hp @1000 RPM ,if max shear stress is 10,000 PSI,angle of twist must be less than 1' /ft/shaft is made of steel.
While calculating the weight of the steel per running meter, the formula used is [(dxd)/162]. Why 162 is used in denominator & how it is derived?
What is Aqua-planing?
why there was 17 stage of compressor in the most of the gas turbine . depending on what?
what is the advantages og idmt relay over magnetic relay??
who is the judge in case of the auditor has raised an NCR against an auditee? who should decide weather this NCR is acceptable and the auditee has to accept?
