Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) Is it possible to convert 4 wire transmitter to convert to 2 wire with additional relay.Please send detial with drawing,i will appreciate.
2 7444a pressure transmitter with a range of 0 to 2500kpag has a specified accuracy of 0.5 % of span.It is to be calibrated using a comparison gauge to have an accuracy of 0.1% of span.The comparison gauge has a range of 0 to 3000kpag What is the accuracy ratio? is this ratio acceptable?
2 4743Why the voltage n frequency of the incoming generator is kept slightly higher than d grid voltage n frequency while synchronization ?
4 131571.Why we have to use inductor in circuits, what is their behavior? 2. Why we have to use capacitor in circuits, what is their behavior?
1 4008if the stetor speed (N S) increase by 20% then the rotor speed will be increased by 20% is it true. ?
4 6242
Dear Sir, i need previous technical question papers, if possible so please tell from where i got these papers.
please send latest placement papers of hpcl officers trainee test. i will be very thankful to you.
Why there are some equipment(i.e:TV) that using 2-pin plug instead of three? What happen if there is current leakage? Are we going to get electric shock??
HELLO ALL OF U.I HAVE QUALIFIED IN SBI CLERICAL WRITTEN EXAMINATION AND MY INTERVIEW IS ON 20TH OF THIS MONTH.IAM SOTWARE BACKGROUNDED CANIDIATE SO CAN ANY ANYBODY WHOSE INTERVIEW IS OVER CAN TELL ME THAT WHAT QUESTIONS THEY ASKED RELATING TO COMPUTER SCIENCE.
What is a sequential circuit and what is a combinational circuit?
Why have to use copper cable for local isolator to motor ?
What fomula is used to calculate: 1. rated frequency withstand voltage, and 2. rated lightning impulse withstand voltage.
Maximum combustion temperature in gas turbines is of the order of 1100 to 10°c whereas same is around 00°c in i.c. Engine ? Why ?
T union support factor
What is meant by reactance voltage?
How much wastages taken in 1. cement 2. steel 3. fine aggregate 4. coarse aggregates (10mm, 20 mm)
why in the three pin plug all 3 pins are cutted ?
What is back stitching?
WHAT IS START TO INDUCTION MOTER IN STAR TO DELTA OF >5HP ?
how pumping of concrete effects the quantity of material used in it?