Answer / guest

Yes. SmartPlant Instrumentation is certified using the same
tools and procedures Intergraph develops and uses to ensure
top quality products.

ON RADAR INTERFACE LEVEL TRANSMITTER IF DI-ELECRIC IS WRONG WITH CONTINIUS PROCESS THAN HOW CAN INDENTIFY OR HOW CAN I PUT NEW DI-ELECTRIC VALUE?(ROSEMOUNT-TDR-3300-COXIAL PROBE TYPE)

1 Answers   Chevron Phillips,

---

What inherent design and operating principles are included in a modern control system to use predictive maintenance practices to increase overall system reliability?

1 Answers  

---

how to install the Ph and Conductivity analyser? is there are any procedures which has to be maintained.

2 Answers  

---

what is the meaning of HART ?

2 Answers  

---

I have a LT of 10000mmwc range. can i use this LT in 1000mmwc range of tank?? if yes than what happened???

3 Answers   Nirma,

---

while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?

1 Answers   Gasco,

---

Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72

1 Answers  

---

can u briefly explain aboutan aryton shunt multirange DC ammeter?

1 Answers  

---

what is mean by TDC-3000

5 Answers   ADCO,

---

What is zener diode? What is voltage regulator?

1 Answers  

---

the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)

1 Answers   GNFC,

---

Coriolis flow meter coil supply is 24vdc but why still we given 230ac for this transmitter let me explained detailed review please

1 Answers   Shell,

---