why do we measure VIBRATION in -24vdc and why we adjust gap
voltage -9vdc to 10-vdc?
i am trying to get this information since 5 years, yet i
haven't get reliable answer, i hope i can get from you.
No Answer is Posted For this Question
Be the First to Post Answer
What is the meaning of Dyn11 of Transformer.
How much ampere can withstand for 2sq mm c able?
What are the neccessary safety arrangements before commissioning of HV substation?
What type of pipe material G.I or M.S is used for sprinkler system?
Is vtg is controlled by the resistor? if else how much?
What type of bulb used in small size cross symbol boder and original flame type(Deepam)?
the input mechanical power of a single alternator is increased,its RPM increased but in case of an alternator synchronised with grid its RPM does not increased with increase of input mechanical power. why?
how much insultion resistance 11kv cable.
why restricted earth fault protection can not operate for phase faults??as there will be a current in secondary of ct,when a phase fault occurs!
why we use lamination or layer by layer cor used?
What is Electricity?
define B types and C types in MCB ?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)