model question paper for supervisor trainee


No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Electrical Engineering Interview Questions

How can we calculate C10 rating of a bttery from c5 or c20 ratings??

1 Answers   Intel,


i need to calculate high voltage line power factor daily basics but there is meter reading kwh and kvah while calculating power factor kwh/kvah formula was right. for examble there is point c=13kwh c=1.8 lag c=1.2 lead and c=14.5kvah like that i know that p.f =kwh/kvah but c=1.8lag kvarh and c=1.2lead kvarh points i dont know if u know please reply

1 Answers  


difference bewteen reverse current and alternating current

0 Answers   ABB,


a bulb of 100W and anather bulb of 200W , rated supply voltage 230v.when supply voltage is reduced to 100v,which bulb will give more light? and why with calculation?

12 Answers  


what is mppt (maximum power point tracking ) and how they used in solar power generation ??? what are the main components used in mppt?????

0 Answers  






what is the difference between isolator and circuit breaker

3 Answers  


In distribution transformers, fuse wires are very thin when compared to conductor size. How it's possible?

4 Answers  


In our factory so many iron pillors are exists for supporting the shed/Hangar. If do more no of earthings at one piller instead of doing more earth pits in many locations and running earth strip around the hanger, I can save the money. Please suggest this method is acceptable as per Is specifications though the Earth resitance of the farthest piller is with in the limits as per IS specifications.

0 Answers   HAL,


which tap of the transormer you will use in critical condition(worst)?

1 Answers  


why swinburnes test cannot be performed on series machines?explain

0 Answers  


as ac supply is given 2 the transformer why it doesnot depends upon powerfactor????

2 Answers  


In alternator generally we give DC voltage to field of alternator but field (excitor)produce Ac & converts into DC by rotating rectifier(RR ) then fed to rotor .my question is why we cannot give dc voltage directly to rotor instead of Excitor & RR ?

1 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)