What is Isolation Current transformer and what purpose to
use it in REF relay ?



What is Isolation Current transformer and what purpose to use it in REF relay ?..

Answer / rajnikanth

isolation transformer is the two winding transformer. it's
used in relays to transform or step down a minimum amount of
required voltage,say 5v from 12 volts.

Is This Answer Correct ?    2 Yes 1 No

Post New Answer

More Electrical Engineering Interview Questions

Diff between Earthed & Unearthed cable ?

1 Answers   Torrent Pharma,


What is the difference bet ween EDO Type & MDO type ACBs, and what is the advantage EDO Type over than MDO type ACBs.

2 Answers   Siemens,


regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?

0 Answers   Reliance, Southco Utility,


what is the meaning of servo motor. In trains, what type of the motors we are using at the bottom of each compartment

5 Answers  


what is the higest transmission voltage and generated voltage in india

14 Answers  






Does all the output contacts (N/O as well as N/C) of a Numerical relay operate when relay receives a binary input/inputs or contacts are designated to specific logic input/inputs and only these contacts operate?

0 Answers  


In Round type three phase transformer why the LV side is inner part and HV outer part in the design of transformer? why they cant be opposite?

2 Answers  


During the main stator winding insulation testing (phase to ground)of 11kv alternator (Lerysomer) i found 0 and resistance with multimeter and found 20 killo ohm while the power cables are connected both end (Generator & VCB). In VCB PT (Potential transformer) are connected. Please any body explain that method of insulation is correct or not? also describe of PT connections

1 Answers   Private,


Why Generator KVA not in KW ?

3 Answers   Bygging India, HHH, Tata Motors, TVS,


Hi, Next week Iam appearing RRB exam for section engineer. So help me to get modal question papers for this position. Iam very thankful to you. Whether question will be fully techanical format or general form. Please give me a details regarding this exam.

0 Answers  


On a 6 KVA UPS we have to provide a DC MCB for Battery bank of 16 nos (12 V 42 AH). What Shall be the current rating of DC MCB ?

0 Answers   TNEB Tamil Nadu Electricity Board,


How to calculate incoming cable size for 33KV, 1MVA transformer.

1 Answers   IAC,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5084)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16631)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1094)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)