a 50hz motor to give 60hz whats happening in motor.what
happen the motor.
Answers were Sorted based on User's Feedback
Answer / jitehs patel
IF MOTOR IS RUNNIG SO AT 60 HZ -SPEED OF MOTOR IS RISE
BECUASE OF N=120F/P ALSO ITS IRON LOSSES OF MOTOR IS
INCREASE.
| Is This Answer Correct ? | 13 Yes | 3 No |
Answer / neeraj katoch
simple if frecuncy is increse the speed of motor is also
increse and vise visa and resulted motor may be burn out
| Is This Answer Correct ? | 10 Yes | 2 No |
Answer / santosh kawade
If we increase only frequency of motor and keep voltage
constant as a rated voltage then speed of motor will
increase but maximum torque capacity of motor will reduce.
Santosh Kawade
9224 69 3116
| Is This Answer Correct ? | 6 Yes | 0 No |
Answer / stalin raj
The motor will run at a speed corresponding to
Ns=120f/p.Due to this high speed the bearings and the
winding insutions get didturbed an the motors get defective.
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / qamar
motor works on v/f=constant, if frequency is increased we
have to increase voltage for satisfactory opearation.
| Is This Answer Correct ? | 4 Yes | 4 No |
Answer / k.boopathi
The motor will run at a speed corresponding to
Ns=120f/p.Due to this high speed the bearings and the
winding insutions get didturbed an the motors get defective.
simple if frecuncy is increse the speed of motor is also
increse and vise visa and resulted motor may be burn out
| Is This Answer Correct ? | 0 Yes | 0 No |
where does 22kv line starts
Why we are use dol starter up to 10 hp
1.what is mean by 8/20 micro sec waveshape
3 measuring instrument for transformers?
what will happen if the secondary of current transformer kept open....
sir what is the purpose of SF6 in HT breaker and what is the pressure should be maintain in the breaker?
the rating of fuse wire i always expressed in what?
What is the difference between ACB & MCCB?
How to Calculate the Fault Level of Electrical Installation
does over charging of a battery reduce its life?
when running 2 nos 450kva dg sets in parallel operation ,in one Dg set power factor and Kvar going to lagging and ampere suddenly going high,please give me suggestion to correct the same.
Briefing the effects of ASR and ACR of a double closed-loop speed regulating system.
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)