How single phase & 3 phase motor select rotating direction ie clockwise/an

Categories >> Engineering >> Electrical Engineering
Suggest New Category

How single phase & 3 phase motor select rotating direction
ie clockwise/anticlockwise

Question Posted / drj

6 Answers
11443 Views
DRJ ARDE, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

How single phase & 3 phase motor select rotating direction ie clockwise/anticlockwise..

Answer / kalinath

i think the direction of rotation depends on the phase
sequence that you are fedding to the winding terminals...

i.e if it is R,Y,B----- clockwise
R,B,Y------anti-clockwise

Is This Answer Correct ?

9 Yes

2 No

How single phase & 3 phase motor select rotating direction ie clockwise/anticlockwise..

Answer / alen

Just by changing the position of two phases wires you will
have the anticlockwise rotation.

Is This Answer Correct ?

3 Yes

0 No

How single phase & 3 phase motor select rotating direction ie clockwise/anticlockwise..

Answer / satyanarayana

clockwise

Is This Answer Correct ?

3 Yes

3 No

How single phase & 3 phase motor select rotating direction ie clockwise/anticlockwise..

Answer / albert mabasa

yes for all questions

Is This Answer Correct ?

0 Yes

0 No

How single phase & 3 phase motor select rotating direction ie clockwise/anticlockwise..

Answer / dinesh jakhar

Normally all motors unidirectional but if there is any special perpous motor then this there is a arrow on drive end side of motor which shows motors direction

Is This Answer Correct ?

0 Yes

0 No

How single phase & 3 phase motor select rotating direction ie clockwise/anticlockwise..

Answer / santosh kawade

single phase and 3 phase motors can be run in both
direction as per design.

DOR (direction of rotation) of motor is depends upon
equipment to which it rotate e.g. pump, fan etc. Mechanical
equipments are unidirectional and we have to adjust motor
direction as per mechanical equipments requirement.

Santosh Kawade
9224 69 3116

Is This Answer Correct ?

1 Yes

2 No

Post New Answer

More Electrical Engineering Interview Questions

415v 14kw so can u tell me how i can measure the cable size.then size of the earth also

1 Answers

which type of ICs can be used in resonant power converter?

1 Answers

why do motors burn out? I understand why adding parallel loads to a power source means more current moves through the circuit, and can destroy circuit elements by overheating. What about when you have a vaccuum cleaner intake flush against a floor, a room fan sitting directly against a wall, or a power drill trying to drill through something too hard?

1 Answers

Why HT voltages are expressed in 11KV,22KV,33KV and so on? (ie in times of 11)

3 Answers Bhel, Park Hotel,

what is the difference between isolation and insolation ? please explain in detail with example.

5 Answers ABB,

If one lamp connects between two phases it will glow or not?

1 Answers

Why we Do not connect the windings of the motor in delta? & what would happen if we do that? I mean the winding themselves not the three lines that are coming to the motor?

1 Answers

sir i am ece engineer.i want to job in power plant.what is the best option for me as electrical engineer or instrumentation engineer?pls reply me.

1 Answers

how to get more than 1000 ohms between 2 earth pits ?

2 Answers HCL,

why can not run two different phase circuit in to the same conduite

1 Answers

what is DG synchronization panel plz explain the working!!!!!!!

12 Answers Kirloskar, Lanco, MPS Techologies, Sedemac,

how can we calculate cable size

1 Answers

For more Electrical Engineering Interview Questions Click Here