Answer / senthil

depends on voltage and current ratings

Hi frnds :) plz tell me that i have 100 KVA 3 phase generator so by thumb rule 100*1.4 = 144 amps and generaly we can operate at 80% load...so it will 144*0.8 =112 amps.... so now i m confused about single phase load.....if we use that generator only for single phase the that 112 amps is total single phase load or i can give 112 amps at red 112 amps at yellow and 112 amps at blue.... i mean that total single phase load that 100 KVA generator will take is 112+112+112=336 amp ??

2 Answers   FWO,

---

Elaborate the term "rotating magnetic field"

2 Answers   APTransco,

---

How To increase Knowledge Of boliler regarding To Only Electrical Field..

0 Answers  

---

what is power system.........?

1 Answers  

---

How to know any size of cable if there are not written on cable? Answer must be theurical not by experience.

0 Answers   El Seif,

---

What is the standard height of installation of Socket & switch from Finish Floor Level as per the IEC/IS Rules?

1 Answers  

---

Voltage drop is the:(a) Maximum potential(b) Difference in potential between two points(c) Voltage at the end of a circuit(d) Voltage produced by a source

3 Answers  

---

What happened when capacitor connect series in ac circuit?

0 Answers  

---

what is pressure relief valve in D.G ?state its function?

3 Answers  

---

whycircuit breaker is not connected at the generator end where the capacity of the generator is more say 60MW, 100MW etc.

2 Answers   Adani, Adani Power,

---

can someone explain that how the speed of the protection system affects the fault level calculation?

0 Answers  

---

How PSV sizing being done

0 Answers  

---