In micro controller individual pin output current is 1.6ma .Normally to blink

In micro controller individual pin output current is 1.6ma
.Normally to blink a led we need minium 10-12 ma. But if
we connect led to the micro controller pins without
additional device it blinks. How it is possible

Question Posted / mgr

0 Answers
2013 Views
I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Electronics Communications Interview Questions

What are the benefits of fibre channel sans?

1 Answers

hi i am electronics & telecomm engg & appling 4 the AAI jr executive (electronics/ATC) written test. pls forward me the syllabus & old question papers.I will be very much thankful to you. shahrukhkhalid911@gmail.com and shahrukh_khalid911@yahoo.co.in

0 Answers AAI Airports Authority Of India, ATC,

i am preparing for AAI JR EXECUTIVE exams so plz suggest the objective materail for preparation

0 Answers AAI Airports Authority Of India,

what is NMC ?

1 Answers

What tools are used to test TCP/IP

0 Answers Mind Tree,

PLEASE SEND ME THE TTA EXAMS PREVIOUS PAPERS TO PREPARE TTA2009

0 Answers BSNL,

what is a state table?

0 Answers

What do you mean by Frequency re-use?

1 Answers

What is Micro Controller and Micro Processor. What is the difference between the two

5 Answers Wipro,

Define virtual grounding?

0 Answers

State the de morgan's theorem?

0 Answers

we r saying that low pass rc filter will allow low frequency components n attenuates the high frequency components..but at low frequency reactance offer by capacitor is high..it will act as open circuit..hence there will no output..but practically we getting output. how?

2 Answers

For more Electronics Communications Interview Questions Click Here