Answer / bilal hamad

1- to isolate supply and load in case of faults and power harmonics (to protect the source) and also to protect the load .

2-KWH: the real power (useful) consumption per hour.
KVAH: the total power consumption per hour.
KVA: the total power (real and imaginary)(vectors sum).
KVARH: the imaginary power consumption per hour.

in summary: the power factor will control the amount of real (active)power and reactive power. all real loads are usually inductive loads or resistive, this will reduce the power factor and then increase the reactive power, the solution is to install capacitor banks to increase the power factor and then reduce the reactive power so increase the active power.

3. CT: is a step down current transformer used for current measurement and protection.
PT or VT: is a step down voltage transformer used for voltage measurement.

How to calculate the size of earth cable to earth the neutral of UPS ?

0 Answers   N Johnson,

---

Do you know how to measure the earth resistance? if so explain it

42 Answers   ABB, BEL, BridgeStone, College School Exams Tests, Dalkia, Dalmia Group, DEC, Electrical, Genpact, HEC, IOCL, JLL, L&T, MSEB, Saraca, Sical, Telecommunications, University Exams,

---

What is gain margin?

0 Answers  

---

reason of capacitor failure or low voltage in alternator wtih 10kva dgset

0 Answers   adag,

---

What is Reactance & Impedance? what is diffrence between these?

2 Answers  

---

what is the difference between series and shunt compensation using facts in a transmission line

8 Answers   College School Exams Tests, Genco,

---

how many types are their in switchyard or substation(like D,I TYPE), what is differant between them

0 Answers  

---

How to know the following data of synchronous generator 1. D-Axis Unsaturated Reactance 2. D-Axis Unsaturated Transient Reactance 3. D-Axis Unsaturated Sub - Transient Reactance

0 Answers  

---

Why the earth cable have current 1A - 2A , it is safety for Electrical system or earth cable should be zero amps ? how to troubleshoot?

0 Answers  

---

Why we use mostly circular coil in transformer? not square or rectangular type of coil.

4 Answers  

---

(1)The demand for electricity , the amount of renewable generation available, the amount of fossil fuel generation available and the cost of the fossil fuel generation are shown in table below period(hrs) demand(MW) renewable (MW) fossil- fuel(MW) cost of fossil fuel(MW) 00.00 - 01.00 2000 1800 2000 30 01.00 - 02.00 2300 2500 2000 30 02.00 - 03.00 2500 2700 2100 45 03.00 - 04.00 2900 3100 2100 50 04.00 - 05.00 2700 2600 2500 45 05.00 - 06.00 2400 2000 2700 50 06.00 - 07.00 2200 1800 2000 36 07.00 - 08.00 2100 1600 2000 36 Assuming that the renewable generation incurs zero cost, determine an optimal generation schedule(specifying the amount of renewable generation and fossil fuel generation used in each period, the cost for each period and the overall cost for 8 hours.)

0 Answers  

---

what is the fuction of electrical transducer in control pannel?

6 Answers  

---