when i am going to take trail on a 3ph sq.i/m motor 5.5kw,
i observed that RPM of the motor is very low as compared to
the rated RPM and also it rotates in clockwise in first ON
command,and anticlock wise in second ON command.
finally i observed that on phase is no available .
but iam not clear about, why the motor is rotates in both
directions without any phase interchanging.pls answer to my
question.
Answer / k.prakashchandra
The direction is changed by interchanging 2 phases and third
phase is taken directly.
| Is This Answer Correct ? | 0 Yes | 3 No |
WHAT IS THE TOTAL POWER GENERATION IN CHHATTISGARH?
in three pin pluge there three pins one is phase and second is earth third is nutral why nutral high diameter compare with phase and earth
What is NUMBER OF RUN for power cable means?
what is the relevance of knee point voltage in protection and metering grade CT ? and basically what is knee point voltage ?
Ratings of power transformer,Distribution transformer.
what composit error,ratio error,phase error in CT and PT??
why cannot we use a freuency more than 400hz is used in aircrafts?
How to test IR testing & magnetic balance test
Sir We have a REF relay connected to 10MVA(Y-Y) Transformer.on External earth fault REF relay trips along with earth fault relay.The REF relay has no complant as we tested relay.Why is it happening?
how can i find cable size from current rating?
Why starters are using the machines???
whether choke act as a voltage regulator in tubelight or not?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)