Answer / Shashikant Kumar

To balance a single-phase load on a Scott connected transformer, you should ensure that the primary and secondary side loads are balanced in terms of impedance (R+jX). This can be achieved by matching the turns ratio of the primary and secondary windings or adjusting the load on one side to equalize the current flowing through both windings. It's important to note that a Scott connected transformer requires balanced loads for efficient operation.

what is the difference between transformer and amplifier ??

5 Answers  

---

Define peak overshoot.

1 Answers  

---

Why 60Hz motor taking more current on load in 50Hz power supply?

1 Answers  

---

What is formula calculation size cable wire ?

1 Answers  

---

why transformer rating in always in KVA ?

4 Answers   Horizon Computers,

---

What is the effect on in Zone and out zone fault if Phase side CT is Vk/2<30 mA and Neutral side is CT is Vk/4<30 mA for Transformer REF protection

1 Answers   ABB,

---

WHERE IS THE LIGHTING ARRESTER SHOULD BE PLACED IN DISTRIBUTION LINES?

26 Answers   APTransco, BARC,

---

dear all, can any body explain that how to select an induction motor for a specific mechanical load(inertia). is there any formula or calculation then please give me. i shell be very thankful to all of you. Thank,s and Rgard,s.

1 Answers  

---

Draw a SLD of HT distribution EB grid up to users Transformer?

1 Answers   HSL, VVL,

---

How much pole motor can be desion for 415 volt ,50 hz.Power supply. in pratical condition . Prakash veer singh

5 Answers  

---

I AM DOIN MY 3RD YEAR IN ELECTRICAL ELECTRONICS. PLEASE SUGGEST WHAT DO I DO NEXT AFTER MY B.E? AND I WANT TO GET INTO ANY PSU IS DER ANY EXAMS PLASE SUGGEST EVEN THAT.

3 Answers  

---

How i can calculate the cable size for given load,there is any formula,for 3 phase and single phase

2 Answers   Prescient Technologies,

---